[新聞資訊] (10/1更新)8043設計瑕疵事件討論

小弟我發現新舊線性伸縮臂有幾個容易分辨出來的地方：

3. 在插入旋轉軸的橘色零件上方處，新的似乎是寫「36X0」，
    而舊的則是寫「18X0」。(這點待其他玩家確認)

GGing 發表於 2010-10-6 16:37

感謝各位回覆

以下借用TBs的圖 ^^
看起來是因為桿子頭被縮小了
所以才會造成伸到最長時
新版LA會有左右晃動的情形
不特別說明的話
右邊的感覺還蠻粗糙的
很有啟蒙的感覺
http://www.eurobricks.com/forum/uploads/m ...
小猴先生 發表於 7/10/2010 09:48

blakbird said...

@conchas

On my excavator, the boom lift actuators were not the only slow ones. They became slow the soonest, but not long after the dipper actuator became just as slow. The bucket worked fine. After the "fix", the boom and dipper are about the same (although it sounds different) and the bucket is noticeably slower and also "bounces" significantly while extending. This is presumably because the threads are not well supported.

A greater concern to me than the speed is the plastic "chips" which Conchas found when taking apart the old actuator. It seems to me that the new actuator will still produce these, and will therefore still wear out over (short) time.

The only thing left I can think of to try is to just take the model apart and start over to see if it is any different.

Wednesday, October 6, 2010 5:11:00 PM GMT+01:00

感謝TBs的持續報導
如何分辨新舊版LAs
http://technicbricks.blogspot.com/2010/10/how-to-easily-distinguish-and-change.html

文中解釋了36X0的確是生產週期的代號
不過把LAs伸到最長的方式
還是最方便的方法

另 ...
小猴先生 發表於 2010-10-11 14:45

8043前面有10211檔路阿...

小猴先生 發表於 2010-10-12 13:06

我買的是新版，最近也剛組裝完成，問題1：換檔不順，電池很有電的時候可以順利換檔，稍稍沒電就換檔失敗，問題二：手臂上升時無力，如使用金頂電池可以順利上升，不過也不持久，用一般電池如"SONY"的電池就幾乎無法 ...
ppgod 發表於 2011-1-5 00:45